KAMP travel speed/acceleration settings

[kemsky]

It seems that KAMP uses speed/accel values that are too high, lowering machine limits does not help. I installed less powerful 0.9 motors on my K1 and they can't handle speed/accel, start skipping steps.

I'm no expert but I found this line in Smart_Park.cfg:

set travel_speed = (printer.toolhead.max_velocity) * 60 | float

Why max_velocity is multiplied by 60?

[kemsky]

ok, travel_speed must be in mm/min but in config we have mm/sec so it is multiplied by 60, but still acceleration seems to be too high.

[VORONENTHUSIAST]

Hi, Kemsky - after getting frustrated with this, I tinkered around in the KAMPS folder by using WINSCP - you can edit the files in there.
You can see from the below screen grab that my change is now implemented when viewing the file in fluid.
Completely forgot about this last night - it's been a while since I've messed around with my printers.

Hope this helps!

[VORONENTHUSIAST]

As an FYI, this was still bugging my motors out - so I changed the travel speed to 12000 (200mm/s) and it's fine now.

[kemsky]

@VORONENTHUSIAST, I did similar thing, changed speed manually.

[VORONENTHUSIAST]

I'm also finding this to be a problem, if I turn Line Purge off it moves to the print position just fine, with it on it bugs my motors out and causes them to loose steps making the print start in the wrong position and crashing my toolhead. Please make it editable

Edit Totally forgot you're able to edit these files in WinSCP!!