G-Codes larger than 100mb

[pitchforknumb]

Hey all. I've run into an issue where I can't upload a file from Orca Slicer that is larger than 100mb directly to my printer. It gives me a HTTP 502 error. I tried downloading the file to my desktop and uploading it in Fluidd and Mainsail that way, but both programs failed uploading. I then tried uploading it into Creality Print and it uploaded it just fine on that program. Is there a workaround for this where I can send the files straight from Orca Slicer?

[Guilouz]

Check moonraker config with max_upload_size parameter.

[pitchforknumb]

It says my max upload size is 1024. I'm guessing that MB's?

[Guilouz]

Yes

[pitchforknumb]

Could time it takes to upload be an issue? I don't have the fastest of Internet.

[Guilouz]

Yes it's possible timeout if your local network don't work as expected.

[martinrevert]

Hey all. I've run into an issue where I can't upload a file from Orca Slicer that is larger than 100mb directly to my printer. It gives me a HTTP 502 error. I tried downloading the file to my desktop and uploading it in Fluidd and Mainsail that way, but both programs failed uploading. I then tried uploading it into Creality Print and it uploaded it just fine on that program. Is there a workaround for this where I can send the files straight from Orca Slicer?

Hi @pitchforknumb , faced the same problem, had to export the gcode fron Orca and upload via SFTP to the gcodes dir over Linux. All other methods failed.

[Guilouz]

You must reinstall Moonraker or replace new service file here : https://github.com/Guilouz/Creality-Helper-Script/blob/main/files/services/S56moonraker_service

[Mr-Au]

I have a similar problem on K1 Max. It error out whenever upload big files. I then ssh into the machine and look at the disk usage, find out that the /tmp is 100%
My workaround is to upload large gcode via Creality's webUI, it will upload to /usr/data which have about 6.5G of space, more than enough for any big gcode files.