Adaptive Meshing problem

[winbard]

Hi,

i have since the last updates and firmware big problem with Adaptive Meshing.
It not work. I not get a first layer when i use this. The print is lose or very bad.
I had make a reset factory, clear chache. Install all new.
I mean the problem is that the Adaptive Meshing not mesh correct. I have two pictures. One full bed mesh and one with Adaptive Meshing. In the small area is the range too high. The hole bed have 0,45 and the Adaptive Meshing 0,29.


Could this possible?

Greets Klaus

[winbard]

Hi,

i test more. I got no good results. I use Orca Slicer and creality ( purge line off and Adaptive Bed mesh off). I get no good results.
Now I see that the distance between the nozzel and the bed is not that what in Klipper show when i make the home drive.
It should be 6mm (z: 6mm) When I measure it is only 5.7-5.8mm. Is this normal?