Firmware 1.3.3.36

[dingausmwald]

Anyone tested this jet?

Newest Version: 1.3.3.36 - 129,14mb

1. Please do a factory reset if you used the root script to install other components, otherwise it might cause errors.
2. Upgrade won't remove fluidd/mainsail, but will overwrite printer configs. Save configs if needed.

Changelog

1. Optimize the logic of filament loading and unloading;
2. Optimize some UI issues;
3. Compatibility with Creality print 5.1;
4. Optimize leveling parameters;
5. Fixed some bugs;

Hope this fixes the bug where the screen freezes on larger prints.

Can't do this atm because they've sent me new left plastic part of the x gantry because one pulley broke after 4 months. Took 5 Days from poland, easy chat through whatsapp. Have to do the repair first. They also have sent me a new toolhead pcb (dono why), new cables and a lidar sensor for free. Just wanted to share this too. Creality support so far ++.

[Strelka13]

Installed new firmware. Now can't connect to mainsail.

[Strelka13]

[dingausmwald]

Did you do a reset or just the update?

[Strelka13]

1. Made update 2) Reset to default 3) Open root 4) Reinstalled mainsail 5) Got error

[dingausmwald]

At least that seams to be the wrong order. Reset first, make update, reinstall stuff (optionally make backup before reset to reapply later)
Maybe your router just assigned another IP address to the printer?

[n8w3rk]

I was able to install everything normally with the script on the new firmware.

[Strelka13]

So tell us please the exact sequence

[Strelka13]

Now I made correct reset first, then installed new firmware and reinstalled Mainsail. After got this error.

[Strelka13]

Ohh my God, printer just needed to be rebooted. Now it's connecting. Case closed))) Thank you!

[n8w3rk]

Reset via script, update OTA, rooting, reinstall everything via script, but use fluidd

[Strelka13]

Correct sequence for new firmware installation: 1) Full printer reset 2) Install new firmware 3) Reinstall Mainsail 4) Reboot printer 5) Enjoy

[feiticeir0]

Well, it didn't work.

After the update, I can't get ssh to the printer (K1C) . The port appears filtered . I've done the root access, waited the 30s and still nothing.

Starting Nmap 7.95 ( https://nmap.org ) at 2024-11-01 17:51 WET
Nmap scan report for 192.168.3.172
Host is up (0.014s latency).
Not shown: 996 closed tcp ports (conn-refused)
PORT     STATE    SERVICE
22/tcp   filtered ssh
80/tcp   open     http
8080/tcp open     http-proxy
9999/tcp open     abyss

Nmap done: 1 IP address (1 host up) scanned in 1.38 seconds

8080 is MJPEG Streamer... ???
How can I get access to the printer now ?