BED NOT HEATING AT EXPECTED RATE (Please read. Interesting issue. Not wiring/thermistor issue.)

[grrminator]

I put a new flatter bed and heater bed on my K1 MAX printer, as detailed in this post

I have verified that the heater bed works fine. Both with varying commands and throughout prints it does NOT fail.

However, it DOES fail when a print finishes, and you start another. It seems to fail when the "START_PRINT EXTRUDER_TEMP=[nozzle_temperature_initial_layer] BED_TEMP=[bed_temperature_initial_layer_single]" engages in orca slicer.

Using M140 S65 and M104 S210 at the same time causes no issue no matter how many timess I do it. It only does it when the bed has already been heated and is coming down from being hot, but only when you use the above mentioned START_PRINT GCode.

The only way to prevent this is to turn the printer off and on after each print, or, restart the firmware. Which to me, seems like a GCode issue somewhere that I cannot seemingly fine.

Can you help me dig into this?

Attached is also my compressed klippy.log (as it was too big to upload to github)
Uploading klippy(3).zip…

[grrminator]

I found where the issue likely is.

I commented out the temp portion of CX_ROUGH_G28 ; EXTRUDER_TEMP={extruder_temp} BED_TEMP={bed_temp}.
Then I added M104 S{extruder_temp} M140 S{bed_temp} Just below that line, issue is that the bed now no longer heats and soakes while doing the KAMP adaptive meshing, I am assuming due to either the Nozzle Clear or Accurate G28 Command.

Anyone have any suggestions or pointers to assist me here to at least soak the bed while it probes?

In the meantime I added M190 S{bed_temp} after the ACCURATE_G28 to test

[grrminator]

Edit, not the Gcode either.

Still does the same issue. I came to the determination that the stock SSR is not up to scrap and got a better one.