diff --git a/README.md b/README.md index 332a0de..e417507 100644 --- a/README.md +++ b/README.md @@ -22,7 +22,7 @@ _Some of the links found on this page may be affiliate links._ - [Filament Sensor](#filament-sensor) - [Probe](#probe) - _Fans_ - - _Extruder_ + - [Extruder](#extruder) 2. [Motherboard](#motherboard) 3. [Lead Screws and Rods](#lead-screws-and-rods) - [Lead Screws](#lead-screws) @@ -213,6 +213,21 @@ You need to make your own cable. I recommend getting these [JST 1.25 cables](htt I bought [this probe: LJ12A3-4-Z-BY](https://s.click.aliexpress.com/e/_DCbT0mD). It's dimensionally correct, however, _completely untested_! +## Extruder + +The parts from a DIY Orbiter V1.5 kit are suitable replacements for this extruder. I'll do a more thorough write-up eventually, but in the meantime, the only parts that differ in the Orbiter are: + +- the 3 pronged stem is longer in the Orbiter though that should not be an issue. +- the flanged bearing has a larger OD in the Orbiter. +- I did not compare the filament gears. + +After over 600 hours of print time, I saw hardly any wear on the gears in the extruder. + +### Aftermarket Options + +- [This](https://s.click.aliexpress.com/e/_DE2NRWZ) is the Orbiter kit that I bought and took measurements from, but any other V1.5 kit should do fine. +- [Mellow](https://s.click.aliexpress.com/e/_DdpgYhT) has a great option as well. + # Motherboard