exclude_object.cfg

[exclude_object]

[gcode_macro M486]
gcode:
  # Parameters known to M486 are as follows:
  #   [C<flag>] Cancel the current object
  #   [P<index>] Cancel the object with the given index
  #   [S<index>] Set the index of the current object.
  #       If the object with the given index has been canceled, this will cause
  #       the firmware to skip to the next object. The value -1 is used to
  #       indicate something that isn’t an object and shouldn’t be skipped.
  #   [T<count>] Reset the state and set the number of objects
  #   [U<index>] Un-cancel the object with the given index. This command will be
  #       ignored if the object has already been skipped

  {% if 'exclude_object' not in printer %}
    {action_raise_error("[exclude_object] is not enabled")}
  {% endif %}

  {% if 'T' in params %}
    EXCLUDE_OBJECT RESET=1

    {% for i in range(params.T | int) %}
      EXCLUDE_OBJECT_DEFINE NAME={i}
    {% endfor %}
  {% endif %}

  {% if 'C' in params %}
    EXCLUDE_OBJECT CURRENT=1
  {% endif %}

  {% if 'P' in params %}
    EXCLUDE_OBJECT NAME={params.P}
  {% endif %}

  {% if 'S' in params %}
    {% if params.S == '-1' %}
      {% if printer.exclude_object.current_object %}
        EXCLUDE_OBJECT_END NAME={printer.exclude_object.current_object}
      {% endif %}
    {% else %}
      EXCLUDE_OBJECT_START NAME={params.S}
    {% endif %}
  {% endif %}

  {% if 'U' in params %}
    EXCLUDE_OBJECT RESET=1 NAME={params.U}
  {% endif %}