probleme max feed

[Dididu12]

BONJOUR A TOUS JAI CETTE ERREUR (MAX FEED) APRES AVOIR REGLER LES PARAMETRE EN HTML DE CONE TRHEAD ECT COMMENT LE RESOUDRE MERCI

[kachurovskiy]

I believe there are 2 potential solutions for this:

1. Use less micro-stepping e.g. 400 steps per revolution instead of 800
2. Lower the MAX_FEED value, e.g. if it's 40, try 20

Cheers!

[Dididu12]

Elle et déjà régler sur 20 d'origine dans le code que dois-je faire merci

[pantonvich]

I have 1mm pitch x - but have a 5/1 gear ratio - I had to use:
MOTOR_X_STEP_PER_REV 1185
SCREW_X 100
MAX_FEED 20
McSTEP_X 1

[Dididu12]

Ok merci c'est avec les systèmes a kachurovskiy

[pantonvich]

I have 13/77

[Dididu12]

Sa marche bien dans l'ensemble se boîtier Arduino

[pantonvich]

I had the same issue - I had to reduce both max_feed and steps. They probably should have a separate max feed for x and x other then using the same one - for my x I can still have it stall out / loose steps at faster speeds - so I need to lower mine more.

[Dididu12]

Quelle et l'axe du croisé et qu'elle et l'axe de la longueur du chariot

[pantonvich]

Sorry I tried translating but don’t understand

[pantonvich]

X and z should have been programmed to used different max feeds but unfortunately they use the same max feed value