You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Recently got the WiCAN set up and logging using BUSMaster. When getting live data I only see (2) modules running in the background with no other data being logged. In the research I've done I always see other peoples logs with 10-20 modules immediately conversing on the bus and so they are able to Reverse Engineer by seeing what values change when a door is opened or pull live data (i.e. Coolant Temp) from the CAN IDs shown on start up. The IDs i see just repeat the same (2) messages back and forth for as long as the vehicle is running. I'm unsure if I have my setting tweaked wrong or I'm only looking at s small group of IDs on the CAN Bus. Any help is appreciated.
The test ran in the logs was trying to activate a front active spoiler via an AUTEL SCANNER and capture communication that happens during this. Is this the data i should be excepting from logging on BUSMaster? I think i should be seeing 20+ more IDs broadcasting Data over the CAN Bus?
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Recently got the WiCAN set up and logging using BUSMaster. When getting live data I only see (2) modules running in the background with no other data being logged. In the research I've done I always see other peoples logs with 10-20 modules immediately conversing on the bus and so they are able to Reverse Engineer by seeing what values change when a door is opened or pull live data (i.e. Coolant Temp) from the CAN IDs shown on start up. The IDs i see just repeat the same (2) messages back and forth for as long as the vehicle is running. I'm unsure if I have my setting tweaked wrong or I'm only looking at s small group of IDs on the CAN Bus. Any help is appreciated.
ATTACHED IS MY BUSMASTER LOG FOR REVIEW
CAN Bus Log 4 With No Motor.log
CAN Bus Log 5 With Motor Plugged in.log
The test ran in the logs was trying to activate a front active spoiler via an AUTEL SCANNER and capture communication that happens during this. Is this the data i should be excepting from logging on BUSMaster? I think i should be seeing 20+ more IDs broadcasting Data over the CAN Bus?
Beta Was this translation helpful? Give feedback.
All reactions