Voxelab Aquila support for PROUI_EX?

[classicrocker883]

since the August update, BOARD_VOXELAB_AQUILA isn't supported as it is a GD32 chip.

even though it runs Maple and it's depreciating, are there plans to bring it back? because these GD32 will not boot using standard STM32F103RC_creality. they so far only can use the _Maple environment

[mriscoc]

There are many reports from users with 4.2.2 board and GD32 SoC, where the normal firmware works for them, it is a bit tricky and depends on a good SD card and format.

[classicrocker883]

maybe that is the issue. the SD cards that came standard with the printers may not be the best.