Calibration Question

[CharlesNNNie]

I have some problems with doing the physical preparation of finding the min/max position.
My Ender 3 v2 has upgraded to Sprite Direct Drive.
I was trying to set the bed size and min/max position of the printer by following the instructions on the wiki page.
In my test when I home and set XY to (0,0) my nozzle is off the Y axis a tiny bit. Then I moved Y up by 10 which perfectly sits on the corner of the bed. I went to the physical setting changed the Y min position to 10 and saved the setting. Then I go back home again and try to move XY to (0,0). However, the Y value only allows me to move to 10 (0,10) but the nozzle Y axis is still off the bed as pervious.
Not sure if I am doing it right?

[CharlesNNNie]

I have set the max y value to - 10 and solve the problem