S1 is not updating when attempting to install the universal firmware #116
-
|
Hello. When I insert a properly formatted and configured SD card into my S1 there is no 10 second delay and the printer boots right up. I've tried a couple different SD cards with the same outcome. Is this an indication that I have the incompatible board by chance. God I hope not. |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 5 replies
-
|
Hi, go to Control / Info and post your current firmware version |
Beta Was this translation helpful? Give feedback.
-
|
It says 3.0.3. I think I saw reference to that number earlier. |
Beta Was this translation helpful? Give feedback.
-
|
Sorry, you have a board with a STM32F4xx. The current firmware version is incompatible with this SoC, only boards with STM32F1xx are supported. |
Beta Was this translation helpful? Give feedback.
-
|
ugh...it's always something it seems. thank you for the quick response. Much appreciation for all you do for the community. |
Beta Was this translation helpful? Give feedback.
-
|
Do you have any idea of what the likelihood might be of getting the STM32F1xx board if I were to request a return/replacement through Amazon? Also, I just purchased a BTT SKR mini E3 V3. Would that be compatible with the S1 as a replacement board? Using a different firmware I would assume? Thanks again. |
Beta Was this translation helpful? Give feedback.
-
|
About of STM32F1xx board, I don't know. |
Beta Was this translation helpful? Give feedback.
Hi, go to Control / Info and post your current firmware version