Which settings would generate the built firmware?

[dhysuiej]

Thanks for this firmware, I've been using it for a while and it's a really awesome.

I decided to try building the firmware myself to see if enabling SMOOTH_ENCODER_MENUITEMS would solve an issue with my printer's knob jumping values all over the place.

I used the settings bellow to build the firmware, the printer is an Ender 3 v2 with CRTouch.

These are the generated files.
MyConfiguration20231209.zip

All I did was to uncomment the '//' in the line with SMOOTH_ENCODER_MENUITEMS and copy the .h files to the Marlin folder, and the file platformio.ini to the root folder, in the default branch of Ender3V2S1 cloned repository.

However when I try the option for manual tramming, before trying to build the mesh automatically, the head goes to the center of the bed and probes that point, then moves a couple centimeters to the front and probes again. Then no matter which corner I select in the manual tramming menu the head just probes the bed in the same spot and doesn't move anywhere else. This issue behavior is not present in the pre-built firmware. So I wanted to see if some could share the exact files (or settings) used in the pre-build firmware Ender3V2-422-BLTUBL-MPC. It would be very much appreciated.

[mriscoc]

Check your mesh inset https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Guides

[dhysuiej]

Thanks a lot 🙂