You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hello, im currently running a Ender 3V2 (BL Touch) with a BTT E3 RRF V1.1 with the STM32F407VGT6 SoC and JyersUI Firmware.
If im not wrong i should have the DWIN Screen, i upgraded the firmware from the screen, when i installed JyersUI.
I'd like to use @mriscoc firmware, but im not sure if it would work with my board, as the SoC is not listed.
Im a noob in coding, but i somehow managed to get JyersUI working with my Ender.
Do you think its possible to upgrade or should i just leave as is?
Thank you :)
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Hello, im currently running a Ender 3V2 (BL Touch) with a BTT E3 RRF V1.1 with the STM32F407VGT6 SoC and JyersUI Firmware.
If im not wrong i should have the DWIN Screen, i upgraded the firmware from the screen, when i installed JyersUI.
I'd like to use @mriscoc firmware, but im not sure if it would work with my board, as the SoC is not listed.
Im a noob in coding, but i somehow managed to get JyersUI working with my Ender.
Do you think its possible to upgrade or should i just leave as is?
Thank you :)
Beta Was this translation helpful? Give feedback.
All reactions