Support for Sprite Extruder Pro #273
-
|
I change my s1 stock extruder to the s1 pro so i can i get it to go over the stock 260' |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 1 reply
-
|
Use the T13 version from: https://github.com/mriscoc/Special_Configurations/releases/tag/AM3950T13 |
Beta Was this translation helpful? Give feedback.
-
|
But I have a S1 with a cr touch So does it matter
…On Sat, Aug 6, 2022 at 12:46 AM Miguel Risco-Castillo < ***@***.***> wrote:
Use the T13 version from:
https://github.com/mriscoc/Special_Configurations/releases/tag/AM3950T13
—
Reply to this email directly, view it on GitHub
<#273 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AZHRQRKR652G5H3FEO5TICTVXX32VANCNFSM55UPECMA>
.
You are receiving this because you authored the thread.Message ID:
***@***.***>
|
Beta Was this translation helpful? Give feedback.
-
|
hi, excuse me, i´m new, how to use the command c104?? |
Beta Was this translation helpful? Give feedback.
-
|
Check the video section in the Wiki. |
Beta Was this translation helpful? Give feedback.
Use the T13 version from: https://github.com/mriscoc/Special_Configurations/releases/tag/AM3950T13