Can UBL and mesh editing be considered in future releases?

[grrmisfit]

UBL being installed and manual tuning of the mesh. the firmware i ran on my v2 had both and is great for those slight adjustments that just happen. we all know the probe isnt perfect and sometimes it needs a little help, being able to go to each probe point and adjust each point up or down would help correct those

[mriscoc]

I could consider those additions, but with the current lack of flash space in the RCT6 chips I must prioritize most used features for the new capabilities.

[harriettubgirl]

I was also curious to know if you might add UBL. I'm just checking out your firmware, great work so far!!

I had just gotten used to UBL so jumping into this has made me uncomfortable again :) Take care

edit: I had to stop using it for now, just don't have the time to mess with it at the moment. I really want to give it another shot sometime though, I was having issues figuring out how to save the mesh. I was trying to report the mesh for bedlevelvisualizer without having to re-run the 9x9 mesh. Wouldn't mind an easier way of handling meshes like a save/load mesh menu would be great. Thanks!

[mriscoc]

To retrieve the mesh for use with the Octoprint bed level visualizer: M420 V
To save the mesh from RAM to EEPROM: Control/Store settings
To get the mesh from EEPROM to RAM: Control/Load settings
To use of the mesh in RAM: M420 S1 Z2

[harriettubgirl]

Thanks for the reply! I'll have to try it out some more soon, take care