S1 Pro Compile Error

[vash2695]

I'm trying to compile FW for the F4 board on my S1 Pro and am having a couple of issues. I'm still pretty new to this so any help would be appreciated!

• Is the memory insufficient to enable both UBL and linear advance?
• If so, are there any default options that can be disabled to free up enough space?
• Even with only linear advance enabled, I swapped the stock hot end fan and am trying to lower the default speed for Fan 1 to a value other than 255 but even in that case it overflowed by 788 bytes. To do this I attempted to change EXTRUDER_AUTO_FAN_SPEED. Aside from changing this value is there any way to set the speed of the extruder fan header elsewhere?

[mriscoc]

#407 (reply in thread)

[vash2695]

That did it, thank you!