Pause/Resume Print #467
-
|
Good Morning Everyone. I have had this issue since installing, it is when I pause a print (either by the runout sensor or manually) once it resumes it will be printing as if it thinks it is shifted left a few cm so the print beyond the resume does not match with the bottom portion, and is shifted over. |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 2 replies
-
|
The printer is trying to go off physical limit when the head is parked. Verify your physical setttings https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Guides |
Beta Was this translation helpful? Give feedback.
-
|
Thanks! |
Beta Was this translation helpful? Give feedback.
-
|
Just got a chance to fix it. It was 232 on both x and y max values with the sprite pro installed. Thank you so much! |
Beta Was this translation helpful? Give feedback.
The printer is trying to go off physical limit when the head is parked. Verify your physical setttings https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Guides