Printer Drawing the first line outside the bed with the provided G Code Script?

[LunarstarPony]

Describe the bug
Printer Drawing the first line outside the bed with the provided G Code Script?

To Reproduce
1, Using the provide G Code Script for Prusa Slicer
2, Print

Expected behavior
Draw the line inside the bed

Screenshots

Version (please complete the following information):
Firmware version and release date
2.1.3 20221002
Additional context
So It does appears that it's drawing inside the bed just very close to the edge so that it's pretty much outside on the actual printer?
Ender 3 V2 Neo

[classicrocker883]

you may need to adjust the X offset, but usually these printers are set to print on 220x220. did u set it to 235x235?

[LunarstarPony]

You mean on the printer settings?

[LunarstarPony]

If I remember correctly it's currently set to default which is 230x230

[LunarstarPony]

I do have a working GCode which is get directly from Creality Slicer but I can't figure out how to get it onto Prusa Slicer
Any idea If can convert this part onto Prusa Slicer?

M420 S1 Z2; Use Level Mesh up to 2mm;
G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X10.1 Y20 Z0.28 F5000.0 ;Move to start position
G1 X10.1 Y200.0 Z0.28 F1500.0 E15 ;Draw the first line
G1 X10.4 Y200.0 Z0.28 F5000.0 ;Move to side a little
G1 X10.4 Y20 Z0.28 F1500.0 E30 ;Draw the second line
G92 E0 ; Reset Extruder
G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X5 Y20 Z0.3 F5000.0 ; Move over to prevent blob squish

[mriscoc]

https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Guides

[LunarstarPony]

The Max min part? I thought it's calibrated for Ender 3 V2 already