Replies: 3 comments
-
|
uhh, so I had the lead screw a bit too tight + misaligned on the carriage / bracket. I adjusted it and aside from it being slightly louder when doing ABL / building a mesh it's pretty slick. |
Beta Was this translation helpful? Give feedback.
-
|
Helpful, thanks for sharing. Waiting to install my dual z kit til this weekend. |
Beta Was this translation helpful? Give feedback.
-
|
Double Motor Z axis, not very good, do a good plan is two screw, synchronous belt synchronization, there will be no double motor pulse signal caused by motor synchronization problem ~ |
Beta Was this translation helpful? Give feedback.
-
So I bought the kit...installed it...and It's not awesome. I have seen some firmware compiled to enable settings for this but the version I have has the Z-cable jumped and going into the board (4.2.7) with one plug...vs. two like maybe some others have? Either way, it kinda sucks and I may just take it off if you all haven't seen it work well with this AWESOME firmware.
Beta Was this translation helpful? Give feedback.
All reactions