-
|
I currently use the pre-compiled versions of this firmware for the 4.2.2 and 4.2.7 boards, manual mesh. Today I was looking at the configuration.h file in the "Ender3V2-422-MM" folder, and I saw that both RESTORE_LEVELING_AFTER_G28 and ENABLE_LEVELING_AFTER_G28 were disabled in this file. Are either of these options enabled in the pre-compiled versions? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
|
No, enabling the leveling system automatically after G28 could have issues with tramming, Z offset and other features of the firmware, so, the leveling system is automatically disabled after G28, that is why a 'M420 S1' or 'G29 A' is required in the Slicer start gcode script. |
Beta Was this translation helpful? Give feedback.
No, enabling the leveling system automatically after G28 could have issues with tramming, Z offset and other features of the firmware, so, the leveling system is automatically disabled after G28, that is why a 'M420 S1' or 'G29 A' is required in the Slicer start gcode script.