Prelaunch Configuration:

1. Install Docker
2. Install weave, see scripts/helper/weave_setup.sh
3. Install Flannel, see scripts/helper/flannel_setup.sh
4. Configure master_ip.txt, just input the IP address of master node
5. Change mode of service, see pkg/util/config/config.go
6. Enjoy hacking!

Usage:

• Build k8s but not run

make build

• Build k8s and run as master and worker

make master

• Build k8s and run as worker

make worker

• Apply node yaml

./kubectl apply -f ./yaml/PodTest/node1.yaml

• Apply a Pod on one host

make testPod

• Apply a Pod, a Service on one host

make testService

• Apply a RS, a Service on one host

make testRS

• Apply a Stress Pod on one host

make testStress

• Apply a Pod, two Services, a gateway on one host

make testGateway

• Apply a Gpu Job on one host

make testGpu

• Apply a serverless test on one host

make testServerless

• Apply a microService test on one host

make testMicroService

• Stop k8s and clear k8s states

make clean

CAUTION:

• If you encounter any problem, try to run make clean, check your iptables if clean and run again. The following command may help to clean iptables made by microService:

docker run --rm --name=istio-init --network=host --cap-add=NET_ADMIN istio/proxyv2:1.16.0 istio-clean-iptables

• Because our etcd is running in container, it has circle dependency with flannel, so it maybe fail when you run just after reboot. Just wait flannel online and rerun make clean and other command again.
• For more information, see doc in doc/ and scripts/